DID YOU KNOW? DTIC has over 3.5 million final reports on DoD funded research, development, test, and evaluation activities available to our registered users. Click
HERE to register or log in.
Accession Number:
AD0260245
Title:
A DIELECTRIC-LOADED LEAKY-WAVE ANTENNA
Corporate Author:
STANFORD RESEARCH INST MENLO PARK CALIF
Report Date:
1961-03-01
Abstract:
The design and the measured performance are described of a flat, leaky-wave antenna in which the inductive, leaky surface is backed with a slab of dielectric. The analysis is based on a transverse resonance analysis which determines the physical dimensions of the antenna for a certain specified aperture distribution. An antenna was built to compare the theoretical behavior with the measured performance. Two ways of forming the dielectric to the antenna were tested. When the dielectric was molded in place the radiation pattern agreed very well with the theoretically predicted pattern, but high losses in the casting resin gave a lower gain for the antenna than anticipated. For a machined piece of dielectric, the radiation pattern was not as close to the predicted pattern as for the molded sample, but the gain was close to the predicted value. The antenna consists of a 28-by-18-inch through filled with a dielectric material over which a sheet of parallel wires is strung. At the design frequency, 4.75 gc, the antenna radiates a pencil beam 9.4 by 8.3 degrees wide at an angle of 54 degrees measured from the normal to the inductive surface. The beam can be scanned from approximately 75 degrees down to 12 degrees from the normal to the aperture by changing the frequency from 5.25 gc to 4.20 gc. Author
Pages:
0001
Contract Number:
AF19 604 3502
File Size:
0.00MB
