Department of Defense Standard Practice for Engineering Drawings.
DEPARTMENT OF DEFENSE WASHINGTON DC
Pagination or Media Count:
This Military Standard is approved for use by all Departments and Agencies of the Department of Defense DoD. Beneficial comments recommendations, additions, deletions and any pertinent data which may be of use in improving this document should be addressed to Commander, U.S. Army Armament Research, Development and Engineering Center, ATM AMSTA-AR-EDE-S, Picatinny Arsenal, NJ 07806-5000, by using the Standardization Document Improvement Proposal DD Form 1426 appearing at the end of this document or by letter. The preferred standard for Engineering Drawing Practices is ASME Y14.lOOM. The contractual application of MIL-STD-lOO is permissible provided one or both of the following conditions exist it is required and fully justifiable that a DoD activity be the design activity the applicable end item requires Government logistics support This Military Standard provides aStandard practices for the preparation of engineering drawings, drawing format and media for delivery. b Requirements for drawings derived from or maintained by Computer Aided Design CAD. c Procedures for the creation of titles for engineering drawings. d Numbering, coding and identification procedures for engineering drawings, associated lists and documents referenced on these engineering drawings and associated lists. e Locations for Marking on engineering drawings.
- Printing and Graphic Arts