The latest procedures developed, that is testing of the section prior to spraying the ends, testing and breakdown of the section after spraying, and soldering using hand iron with very careful control of temperature was followed in order to obtain the greatest maximum number of good units. It was found that sealing in the cans, that is the soldering of the glass end seals into the can after the insertion of the capacitor sections, was also a very critical operation since there was sufficient heat transfer from the soldering operation to the section to affect the contact resistances of the end connection. However, a sufficient number of units was obtained to permit continuation of the testing. Not all of the units met the exact requirements of the Specification. However, it was thought worthwhile to select the best units for the continuation of the testing.