Accession Number : ADA623154


Title :   Effect of Prior Exposure at Elevated Temperatures on Tensile Properties and Stress-Strain Behavior of Four Non-Oxide Ceramic Matrix Composites


Descriptive Note : Master's thesis


Corporate Author : AIR FORCE INSTITUTE OF TECHNOLOGY WRIGHT-PATTERSON AFB OH GRADUATE SCHOOL OF ENGINEERING AND MANAGEMENT


Personal Author(s) : Wallentine, Sarah M


Full Text : https://apps.dtic.mil/dtic/tr/fulltext/u2/a623154.pdf


Report Date : 18 Jun 2015


Pagination or Media Count : 271


Abstract : Thermal stability of four non-oxide ceramic matrix composites was studied. The materials studied were commercially available composites: SiC/SiNC; C/SiC; C/SiC-B4C (C/HYPR-SiC(trademark)); and SiC/SiC-B4C (SiC/HYPR-SiC(trademarkr)). COI Ceramics manufactured the SiC/SiNC and C/SiC composites using polymer infiltration and pyrolysis (PIP). The C/HYPR-SiC(trademark) and SiC/HYPR-SiC(trademark) CMCs were manufactured by Hyper-Therm High-Temperature Composites using chemical vapor infiltration (CVI). All four composites rely on a dense matrix for strength, stiffness, and oxidation protection. Fiber coating provides a fiber-matrix interface that allows fiber-matrix debonding and fiber pullout to occur, imparting fracture toughness to the CMC. The SiC/SiNC, C/SiC, and C/HYPR-SiC(trademark) composites were heat treated in laboratory air for 10 h, 20 h, 40 h, and 100 h at over-temp (1300 deg C) and for 100 h at operating temperature (1200 deg C). The SiC/HYPR-SiC(trademark) composite was heat treated in laboratory air for 10 h, 20 h, 40 h, and 100 h at over-temp (1400 deg C) and for 100 h at operating temperature (1300 deg C). Room-temperature tensile properties of heat treated and virgin material were measured, and effect of prior heat treatment on tensile properties was evaluated. Prior heat treatment caused a reduction of tensile strength of at least 10% for all materials. Both PIP-produced CMCs exhibited increased fiber-matrix bonding due to high temperature exposures, contributing to brittle fracture of clumped fiber bundles and thus reduced tensile strength. Both CVI-produced CMCs exhibited considerable matrix voids due to poor infiltration during fabrication. Void prevalence and the associated stress concentrations contributed to premature matrix cracking and composite failure. The CVI CMCs were susceptible to degraded tensile properties and brittle composite fracture due to strengthened fiber-matrix interfaces and fiber degradation caused by prior heat treatment.


Descriptors :   *CERAMIC MATRIX COMPOSITES , *STRESS STRAIN RELATIONS , *TENSILE PROPERTIES , BORON CARBIDES , CERAMIC FIBERS , COMPOSITE MATERIALS , EXPOSURE(GENERAL) , FIBER REINFORCED COMPOSITES , HIGH TEMPERATURE , OXIDES , SILICON CARBIDES , THERMAL STABILITY


Subject Categories : Ceramics, Refractories and Glass


Distribution Statement : APPROVED FOR PUBLIC RELEASE