Accession Number : ADA181902
Title : The Design of a Four Square Gear Tester for Noise and Vibration Measurements.
Descriptive Note : Master's thesis,
Corporate Author : PENNSYLVANIA STATE UNIV UNIVERSITY PARK APPLIED RESEARCH LAB
Personal Author(s) : Vilanilam, Santosh V ; Pechersky, M J
Report Date : Dec 1986
Pagination or Media Count : 180
Abstract : The following report provides the design procedures for a Four Square Gear Tester. The primary purpose of the testes is to investigate noise generation in spur gears that result from two major sources: 1) Dynamic Loads and 2) Fluid Dynamics. The tester is designed to operate at 9000 rev/min with an applied shaft load of 301.11 in-1lbs. The design includes mechanical components, such as: 1) A dc shunt-wound electric motor (with SCR) which will allow testing to be performed over wide range of loading as well as speed, 2) A speed increasing mechanism consisting of pulleys and V-belts to provide the desired range of speed and torque, 3) Air bearings which are intended to minimize extraneous vibrations and provide good shaft alignment, 4) Flexible shaft couplings, with a low degree of dynamic imbalance and bending force transmission, to accommodate both angular and parallel shaft misalignment, 5) Gear mounts, also with low dynamic imbalance and with the required torque rating, to fasten the gears to the shaft; and 6) Precision ground steel shafts which will provide center-to-center accuracy and therefore minimize vibration. In addition a pressure-spray lubrication system was also selected to cool and lubricate the mating gear teeth.
Descriptors : *RADIATED NOISE , *GEAR NOISE , *GEARS , GAS BEARINGS , SHAFTS(MACHINE ELEMENTS) , DYNAMIC LOADS , FLUID DYNAMICS , NOISE GENERATORS , ANGLES , MISALIGNMENT , BENDING , TRANSMITTANCE , FLEXIBLE COUPLINGS , FLEXIBLE SHAFTS , MOUNTS , MECHANICAL COMPONENTS , PARALLEL ORIENTATION , GROUND LEVEL , PRECISION , STEEL , HOISTS , ALIGNMENT , TESTES , RATINGS , TORQUE , MEASUREMENT , VIBRATION , RANGE(EXTREMES) , LUBRICATION , PRESSURE , SPRAYERS , VELOCITY
Subject Categories : Test Facilities, Equipment and Methods
Distribution Statement : APPROVED FOR PUBLIC RELEASE